Synthetic Resin Adhesive for flap disc automatic machine

1.quickly solidify, 2.high final bonding strength, 3.good ageing resistance, 4.low amount of spraying,etc

Technical characteristics

1. Should be poured the adhensive rapidly.

2. After pouring the glue ,Colloidal will spread fast , and the probability of emery cloth fall down is low.

3. High resin solid content , solidifying material has high bonding, high heat resistance and good toughness.

 

performance index

 

Iterm	Data	Test methods
Viscosity mpa·s80°C	9000-150000	GB/T2794
Ohms(Ω)·cm	>5.0×1012	Coated 170°C solity 2h
Shearing strength in normal temperature ( mpa)	>12.0	GB/T7124
200°C Shearing strength (mpa)	>2.0	GJB444
non-volatile matter	>99%	GB/T2703
Data of rewind in normal temperature	>21000

 

Method of use

1. Before use the  Synthetic Resin Adhesive need preheated  in ( 50-60 ) °C  for 60min, after installed on the machine the Synthetic Resin Adhesive temperature is 45-50°C.

2. After assemble the flap disc  should be put into  the oven with the temperature up to 130°C and heat preservation for 2h-3h . 

 

Packing

Colloidal packing 25kg per barrel, or can also be based on customers demand using non-standard packaging.

 

Safety

Colloid belongs to low toxic chemicals, should avoid entering eyes, oral.

 

Storage and packaging

1. Below 25°C storage, relative temperature under the condition of <70%, 6 months shelf-life, over shelf life after composite lattice can continue to use.

2. This product is not dangerous goods, according to the transport of chemicals in general.

 

Notes

The above performance data for the product to a temperature of 70%, temperature 25°Ctest of typical data, only to provide customers with the reference, and can not be fully guaranteed in a specific environment can achieve all the requirements, please customers use, based on the measured data.

 

 

 

...

Synthetic Resin Adhesive for flap disc automatic machine